Gecko in.therm heater for in.xm and in.xm2

The Gecko in.therm 2 kW heater works with the Gecko in.xm and in.xm2 spa pack.

It has been reconditioned and is in perfect working order.

The heater has a built-in temperature sensor and an electronic flow-detection function with no moving parts. It has a high degree of waterproofing, and its electronic components are embedded in epoxy, to protect against the stress of vibrations caused by the flow of water.

Dimensions
370 x 127 x 114 mm

Pipe unions
This heater, unlike most spa heaters, has a male threaded connection at each end, with a 2" MBT thread, the same thread standard that is found on most hot tub pumps. You can therefore connect your pipes using standard pump unions with a 78 mm nut. We offer these unions for 63 mm, 2-inch and 1.5-inch pipes.

Warranty
6-month Tubs Parts warranty

Gecko part numbers
2 kW: 0603-421003