Gecko in.touch 2 WiFi controller

With the Gecko in.touch 2, you can control your hot tub from your iOS (iPad, iPhone, iPod) and Android smartphone or tablet.

The in.touch 2 eliminates all the complexities of connecting your spa to the Internet and transforms your smartphone or tablet into your ultimate Wi-Fi spa remote control. in.touch 2 comes with its app (download it on your store) and 2 prepaired radio frequency transmitters, one being part of your spa system and the second one being connected to your Internet router.

Both RF transmitters are prelinked to one another, enabling an immediate and perfect communication between you and your spa. It provides a strong and long range communication signal, and makes it very easy to control and program all the functions and features of your spa from your smartphone or your tablet.

Even when you’re away from home, you get full control of your water care settings, filtration cycles, water temperature, economy modes and a lot more, even the in.temp heat pump. Push notifications will always keep you informed on the status of your spa, even when your app is not open.

Installation instructions (see Technical documentation for more details)
To install the Home Module inside your house, connect it to a LAN port on your Internet router using the Ethernet cable. To power up your home transmitter, connect your cable to the supplied power supply (220V) and to the micro-USB power supply of your in.touch 2 transmitter.

Simply connect the Spa Transmitter module into an available CO port of the spa pack (or any other accessory with a free CO port, such as the in.stream 2 audio amplifier, or the in.clear spa sanitizing system). The Spa Transmitter only has a single CO cable and thus must be installed at the end of the CO chain if more than a single accessory is installed on the same CO port of the spa pack.

If you purchase a spa that is already equipped with an in.touch 2, or optional, the transmitter will already be installed on your control system.

Compatibility
in.xm2, in.xe, in.yj-3, in.ye-3, in.ye-5 et in.yt-7 (software 85 rev 4.00 and up)

The kit includes two communication transmitters (spa transmitter, with a 2 m cable, and home transmitter with a 90 cm ethernet cable ), a wall mount power adaptor and 90 cm cable.

For your information, in.touch 2 cannot be used directly if you subscribe to Starlink (satellite internet). For any installation, we advise you to call in a qualified technician.

Warranty
2 years Tubs Parts warranty

Part numbers
Gecko : 0608-521021, 0608-521037