LX Whirlpool H30-R3 heater

This heater is equipped with a pressure switch, to prevent the heater from turning on without the pump running. On some spas, this pressure switch is connected directly to the control system by a cable. If your current heater is equipped with two cables (a large power cable and a small control cable, as shown in the picture opposite), you will need the version WITH control cable. If you only see the power cable, order the version WITHOUT control cable. In case of doubt, call us!

This heater is also a very good replacement for the H20-R3 models. The H30 will heat up faster than the H20 version, but it will not consume more energy in total (the heating is more intense, but for a shorter time).

Dimensions
Length: 298 mm
Width: 180 mm
The LX Whirlpool H30-R3 heater is supplied with unions and o-rings for 1.5-inch (48 mm) pipes.

Warranty
2-year Tubs Parts warranty

Part numbers
LX Whirlpool : H30-R3
Replaces the RSL "Rooster" heater